36 CHAPTER 1: GETTING STARTEDBy default, the specified logged-in user can access the commands at Level 1.Setting the Command Level used after a User Logs In from a UserInterface You can use the following command to set the command level after auser logs in from a specific user interface, so that a user is able to execute thecommands at such command level.Perform the following configuration in User Interface View.By default, a user can access the commands at Level 3 after logging in through theAUX user interface, and the commands at Level 0 after logging in through the VTYuser interface.When a user logs in to the Switch, the available command level depends on twopoints. One is the command level that the user is allowed to access, the other isthe set command level of this user interface. If the two levels are different, theformer will be taken. For example, the command level of VTY 0 user interface is 1,however, you have the right to access commands of level 3; if you log in from VTY0 user interface, you can access commands of level 3 and lower.Setting the Command Priority The following command is used for setting thepriority of a specified command in a certain view. The command levels includevisit, monitoring, system, and management, which are identified with 0 through 3respectively. An administrator assigns authorities as per user requirements.Perform the following configuration in System View.Do not change the command level unnecessarily for it may cause inconveniencewith maintenance and operation.Restore the defaultcommand level used aftera user logs inundo service-type { ftp [ ftp-directory ]lan-access | { ssh | telnet | terminal }* }Table 25 Setting the Command Level used after a User Logs In from a User InterfaceOperation CommandSet command level used after a user logs in from auser interfaceuser privilege level levelRestore the default command level used after a userlogs in from a user interfaceundo user privilege levelTable 26 Setting the Command PriorityOperation CommandSet the command priorityin a specified view.command-privilege level level view view commandRestore the defaultcommand level in aspecified view.command-privilege view view commandTable 24 Setting the Command Level used after a User Logs InOperation Command
