Unit Object Commandswww.3ware.com 55/cx/ux show verifystatusThis command reports the verifystatus (if any) of the specified unit.Examples://localhost> /c0/u5 show verifystatus/c0/u5 is not verifying, its current state is OK/cx/ux show initializestatusThis command reports the initializestatus (if any) of the specified unit.Examples://localhost> /c0/u5 show initializestatus/c0/u5 is not initializing, its current state is OK/cx/ux show nameThis feature only applies to 9000 series controllers.This command reports the name (if any) of the specified unit.Examples://localhost> /c0/u5 show name/c0/u5 name = Joe/cx/ux show serialThis feature only applies to 9000 series controllers.This command reports the unique serial number of the specified unit.Examples://localhost> /c0/u5 show serial/c0/u5 Serial Number = 12345678901234567890/cx/ux show qpolicyThis feature only applies to 9550SX model controllers.This command reports the queue policy of the firmware. If the queue policy ison, the firmware utilizes the drive queueing policy. If some drives in the unitdo not support a queueing policy, this policy will have no effect on thosedrives.Note that currently only NCQ will be enabled, not tag-queueing.Example://localhost> /c0/u5 show qpolicy/c0/u5 Command Queuing Policy = on
