ABB ACS255 User Manual

Also see for ACS255: User manual User guide

Contents

ABB ACS255 User Manual Manual pdf 33 page image

3419 O: StopC: Run FwdO: StopC: Run RevDigital input 3 Analog input 1 Preset SpeedO: Selected Speed RefC: Preset speed 1 .. 4Off Off Preset Speed 1On Off Preset Speed 2Off On Preset Speed 3On On Preset Speed 420 O: StopC: Run FwdO: StopC: Run RevNormally Open (N.O.)Close to increase speedNormally Open (N.O.)Close to reduce speedO: Selected Speed RefC: Preset speed 121 Normally Open (N.O.)Close to run FwdNormally Closed(N.C.)Open to StopNormally Open (N.O.)Close to run Rev Analog 1 Speed reference O: Selected Speed RefC: Preset speed 1Note1) The drive will immediately ramp at the rate set in parameter 2206 2nd DECELERATION RAMP TIME.2) If a motor thermistor (PTC type only, or normally closed thermal switch contact) is to be connected, this must be selected inparameter 1304. Connect the thermistor between terminal 1 and terminal 10.8.2. Macro wiring configurations.9902 = 1(Default Macro) Open Closed 9902 = 2 Open Closed1 +24 Volt Common 1 +24 Volt Common2 Stop Run 2 Stop Run3 Forward Rotation Reverse Rotation 3 Forward Rotation Reverse Rotation4 Selected Speed ref Preset Speed ref 4T4 T6 T10 Preset5 +10 Volt 56 Analog Input 1 6 Open Open Open 12027 0 Volts 7 Closed Open Open 12038 8 Open Closed Open 12049 0 Volts 9 Closed Closed Open 120510 Preset Speed 1(1202) Preset Speed 2(1203)(1203(10ormalOperation11 1112 Safe Inhibit Normal Operation 12 Safe Inhibit Normal Operation13 Safe Inhibit Normal Operation 13 Safe Inhibit Normal Operation9902 = 3 Open Closed 9902 = 4 Open Closed1 +24 Volt Common 1 +24 Volt Common2 Stop Run 2 Stop Run3 Forward Rotation Reverse Rotation 3 Forward Rotation Reverse Rotation4 Selected Speed ref Preset Speed 1 (1202) 4 Selected Speed ref Preset Speed 1 (1202)5 +10 Volt 5 +10 Volt6 Analog Input 1 6 Analog Input 17 0 Volts 7 0 Volts8 89 0 Volts 910 Analog input 2 (E.g. Torque Reference) 10ormalOperationDecel ramp 1 (2203) Decel ramp 2 (2206) 1)11 1112 Safe Inhibit Normal Operation 12 Safe Inhibit Normal Operation13 Safe Inhibit Normal Operation 13 Safe Inhibit Normal OperationNote1) The drive will immediately ramp at the rate set in parameter 2206 2nd DECELERATION RAMP TIME.9902 Digital Input 1(Terminal 2)Digital Input 2(Terminal 3)Digital Input 3(Terminal 4)Analog Input 1(Terminal 6)Analog Input 2(Terminal 10)