Start-up, control with I/O and ID run 61 How to perform a manual start-upFor the manual start-up, you can use the basic control panel or the assistant controlpanel. The instructions below are valid for both control panels, but the displays shownare the basic control panel displays, unless the instruction applies to the assistantcontrol panel only.Before you start, ensure that you have the motor nameplate data on hand.POWER-UPApply input power.The basic control panel powers up into the Outputmode.The assistant control panel asks if you want to runthe Start-up assistant. If you press , the Start-up assistant is not run, and you can continue withmanual start-up in a similar manner as describedbelow for the basic control panel.MANUAL ENTRY OF START-UP DATA (parameter group 99)If you have an assistant control panel, select thelanguage (the basic control panel does notsupport languages). See parameter 9901 for thevalues of the available language alternatives.For instructions on how to set parameters with theassistant control panel, see section Assistant controlpanel on page 87.Select the motor type (9903).• 1 (AM): Asynchronous motor• 2 (PMSM): Permanent magnet motor.Setting of parameter 9903 is shown below as anexample of parameter setting with the basic controlpanel. You find more detailed instructions in sectionBasic control panel on page 75.1. To go to the Main menu, press if the bottom lineshows OUTPUT; otherwise press repeatedlyuntil you see MENU at the bottom.2. Press keys / until you see “PAr”, andpress .3. Find the appropriate parameter group with keys/ and press .4. Find the appropriate parameter in the group withkeys / .REM HzOUTPUT FWD00.EXIT Do you want touse the start-upassistant?YesNoEXIT OK00:00REM CHOICE9901 LANGUAGECANCEL SAVE00:00PAR EDIT[0]ENGLISHREMREMPAR FWD9903REMMENU FWDrEFREMPAR FWD-01-REMPAR FWD9901REMPAR FWD9903
