Control panels 93 Output modeIn the Output mode, you can:• monitor actual values of up to three signals in group 01 OPERATING DATA• change the direction of the motor rotation• set the speed, frequency or torque reference• adjust the display contrast• start, stop, change the direction and switch between local and remote control.You get to the Output mode by pressing repeatedly.The top right corner of thedisplay shows the referencevalue. The center can beconfigured to show up to threesignal values or bar graphs. Ifjust one or two signals areselected for display, the number and name of each displayed signal are shown inaddition to the value or bar graph. See page 96 for instructions on selecting andmodifying the monitored signals.How to change the direction of the motor rotationStep Action Display1. If you are not in the Output mode, press repeatedlyuntil you get there.2. If the drive is in remote control (REM shown on the statusline), switch to local control by pressing . The displaybriefly shows a message about changing the mode andthen returns to the Output mode.3. To change the direction from forward ( shown on thestatus line) to reverse ( shown on the status line), orvice versa, press .Note: Parameter 1003 DIRECTION must be set to 3(REQUEST).EXITDIR MENU00:00LOC 49.1Hz49 1 Hz.0 5 A.10 7 %. DIR MENU00:00LOC 5.0Hz0 4 A.24 4 %.Hz50%EXITDIR MENU00:00REM 49.1Hz49 1 Hz.0 5 A.10 7 %.LOCREMDIR MENU00:00LOC 49.1Hz49 1 Hz.0 5 A.10 7 %.DIRDIR MENU00:00LOC 49.1Hz49 1 Hz.0 5 A.10 7 %.
