Motor control and I/O board (RMIO)66Note on external power supplyExternal +24 V power supply for the RMIO board is recommended ifï the application requires a fast start after connecting the input power supplyï fieldbus communication is required when the input power supply is disconnected.The RMIO board can be supplied from an external power source via terminal X23 orX34 or via both X23 and X34. The internal power supply to terminal X34 can be leftconnected when using terminal X23.WARNING! If the RMIO board is supplied from an external power source viaterminal X34, the loose end of the cable removed from the RMIO board terminalmust be secured mechanically to a location where it cannot come into contact withelectrical parts. If the screw terminal plug of the cable is removed, the wire endsmust be individually insulated.Parameter settingsIn Standard Control Program, set parameter 16.9 CTRL BOARD SUPPLY toEXTERNAL 24V if the RMIO board is powered from an external supply.
