Technical data 169CE markingA CE mark is attached to the drive to verify that the drive follows the provisions of theEuropean Low Voltage, EMC and RoHS Directives. The CE marking also verifies thatthe drive, in regard to its safety functions (such as Safe torque off), conforms with theMachinery Directive as a safety component. Compliance with the European Low Voltage DirectiveThe compliance with the European Low Voltage Directive has been verified accordingto standards EN 60204-1 and EN 61800-5-1. Compliance with the European EMC DirectiveThe EMC Directive defines the requirements for immunity and emissions of electricalequipment used within the European Union. The EMC product standard (EN 61800-3:2004) covers requirements stated for drives. See section Compliance with theEN 61800-3:2004 below.Applicable standardsThe drive complies with the following standards. The compliance with the European LowVoltage Directive is verified according to standard EN 61800-5-1.EN 60204-1:2006 + A1 2009 Safety of machinery. Electrical equipment of machines.Part 1: General requirements. Provisions for compliance:The final assembler of the machine is responsible forinstalling- emergency-stop device- supply disconnecting device.IEC/EN 60529:1991 + A1 2000 Degrees of protection provided by enclosures (IP code)IEC 60664-1:2007 Insulation coordination for equipment within low-voltagesystems. Part 1: Principles, requirements and tests.EN 61800-3:2004 Adjustable speed electrical power drive systems. Part 3:EMC requirements and specific test methodsEN 61800-5-1:2007 Adjustable speed electrical power drive systems. Part 5-1:Safety requirements – electrical, thermal and energyEN 61800-5-2:2007 Adjustable speed electrical power drive systems. Part 5-2:Safety requirements – FunctionalUL 508C:2002 UL Standard for Safety, Power Conversion Equipment,third editionNEMA 250:2008 Enclosures for Electrical Equipment (1000 VoltsMaximum)CSA C22.2 No. 14-10 Industrial control equipmentGOST R 51321-1:2007 Low-voltage switchgear and control gear assemblies. Part1 - Requirements for type-tested and partially type-testedassemblies - General technical requirements and methodsof tests
