Name Type DescriptionSTNDZRV BOOLEAN Start in any phase or phases from zone RV - anydirectionSTND BOOLEAN Fault detected in any phase or phases - anydirectionSTNDL1 BOOLEAN Fault detected in phase L1 - any directionSTNDL2 BOOLEAN Fault detected in phase L2 - any directionSTNDL3 BOOLEAN Fault detected in phase L3 - any directionSTNDPE BOOLEAN Fault with earth connection detected in any phaseor phases - any directionSTFWL1 BOOLEAN Fault detected in phase L1 - forward directionSTFWL2 BOOLEAN Fault detected in phase L2 - forward directionSTFWL3 BOOLEAN Fault detected in phase L3 - forward directionSTFWPE BOOLEAN Fault with earth connection detected - forwarddirectionSTRVL1 BOOLEAN Fault detected in phase L1 - reverse directionSTRVL2 BOOLEAN Fault detected in phase L2 - reverse directionSTRVL3 BOOLEAN Fault detected in phase L3 - reverse directionSTRVPE BOOLEAN Fault with earth connection detected - reversedirectionSTFW1PH BOOLEAN Single-phase fault detected - forward directionSTFW2PH BOOLEAN Two-phase fault detected - forward directionSTFW3PH BOOLEAN Three-phase fault detected - forward directionSTPE BOOLEAN Ph-E zone measurement enabled - any directionSTPP BOOLEAN Ph-Ph zone measurement enabled - any direction6.1.5 SettingsPID-7066-SETTINGS v1Table 34:ZMFPDIS Non group settings (basic)Name Values (Range) Unit Step Default DescriptionGlobalBaseSel 1 - 12 - 1 1 Selection of one of the Global BaseValue groupsZDbRepInt 1 - 100000 Type 1 10 Cycl: Report interval (s), Db: In % ofrange, Int Db: In %sZMax 0.0 - 5000.0 Ohm 0.1 1500.0 Maximum value in ohmZRepTyp CyclicDead bandInt deadbandDead band & 5sCyclicDead band & 30sCyclicDead band & 1minCyclic- - Cyclic Reporting typeZAngDbRepInt 1 - 100000 Type 1 10 Cycl: Report interval (s), Db: In % ofrange, Int Db: In %s1MRK 506 382-UEN A Section 6Impedance protectionLine distance protection REL650 2.2 IEC 91Technical manual
