ABB RETA-01 User Manual
Also see for RETA-01: User manual
                                                                                      | |
Contents
| 
Mechanical installation29Mechanical installationWARNING! Follow the safety instructions given in this manual andin the Hardware Manual of the drive.MountingThe RETA-01 is to be inserted into its specific position in the drive.The module is held in place with plastic retaining clips and twoscrews. The screws also provide the earthing of the CAT 5 STPcable shield connected to the module, and interconnect the GNDsignals of the module and the control board of the drive.On installation of the module, the signal and power connection tothe drive is automatically made through a 34-pin connector.Mounting procedure:ï Insert the module carefully into its position inside the drive untilthe retaining clips lock the module into position.ï Fasten the two screws (included) to the stand-offs.ï Set the IP address DIP switch of the module to the requiredposition.Note: Correct installation of the screws is essential for fulfilling theEMC requirements and for proper operation of the module. |
Related manuals for ABB RETA-01
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine