• Abbreviations and acronyms are spelled out in the glossary. The glossary alsocontains definitions of important terms.• Push button navigation in the LHMI menu structure is presented by using thepush button icons.To navigate between the options, use and .• Menu paths are presented in bold.Select Main menu/Settings.• WHMI menu names are presented in bold.Click Information in the WHMI menu structure.• LHMI messages are shown in Courier font.To save the changes in nonvolatile memory, select Yes and press .• Parameter names are shown in italics.The function can be enabled and disabled with the Operation setting.• The ^ character in front of an input or output signal name in the function blocksymbol given for a function, indicates that the user can set an own signal name inPCM600.• The * character after an input or output signal name in the function block symbolgiven for a function, indicates that the signal must be connected to anotherfunction block in the application configuration to achieve a valid applicationconfiguration.1.4.3 Functions, codes and symbolsTable 1:Functions included in the IEDsDescription IEC 61850 IEC 60617 ANSIProtectionThree-phase non-directionalovercurrent protection, low stagePHLPTOC 3I> 51P-1Three-phase non-directionalovercurrent protection, high stagePHHPTOC 3I>> 51P-2Three-phase non-directionalovercurrent protection,instantaneous stagePHIPTOC 3I>>> 50P/51PVoltage dependent overcurrentprotection PHPVOC I(U)> 51VThree-phase directionalovercurrent protection, low stageDPHLPDOC 3I> -> 67-1Three-phase directionalovercurrent protection, high stageDPHHPDOC 3I>> -> 67-2Distance protection DSTPDIS Z< 21, 21P, 21NAutomatic switch-onto-fault logic CVRSOF SOTF SOTFFault locator SCEFRFLO FLOC 21FLAutoreclosing DARREC O -> I 79Non-directional earth-faultprotection, low stageEFLPTOC I0> 51N-1Table continues on next pageSection 1 1MRS756509 EIntroduction8 630 seriesOperation Manual