Operation Manual / TPL65-A32 / -A33 / -A36 + TPL69-A32 / -A33Removal and installation 7Installing the turbocharger 7.3 Page 84© Copyright 2016 ABB. All rights reserved.November 2016HZTL2498_ENRevision BInstalling the turbocharger7.3 Remove cover from oil connection. Inspect lifting gear. Fasten separate lifting gear to each of two bearing casing ribs provid-ed for this purpose.CAUTIONOil orifice platesAn orifice plate for adjusting the oil pressure is fitted in each of the twooil inlet channels in the bearing casing. When the cartridge group, thebearing casing or the turbocharger is fitted to the engine, it must be en-sured that the orifice plates that are specified for the turbocharger havebeen installed in the two oil inlet channels. Check correct installation of oil orifice plates. Adapt turbocharger to suit engine. Tighten fixing screws in foot in accordance with engine builder's in-structions. Fasten gas, air and oil lines in accordance with engine builder’s in-structions.TPL65: Version with compressor wheel cooling system Fit air supply line. (See also chapter Preliminary remarks / Layout andfunctioning.) Refit removed parts of insulation. Plug in cable connector on speed sensor.7.3
