Description of application and parametersApplication "1-button value transmitter"KNX Technical Reference Manual 1473-1-8905 / 2CKA001473B8905 │3710.7.2 Extended parameters - Reaction on rising edgeOptions: No reactionValue 1Value 2Alternating value1/value2The application can differentiate between the operation and the releasing of the button. Anoperation is designated as "Rising edge" and the releasing is designated as "Falling edge".The application "1-button value transmitter" makes two separate "Switching" communicationobjects available for the left or right side of the button. The value 1 is always sent out on the firstobject (Value 1) and the value 2 is always sent out on the second object (Value 2).The "Reaction to falling edge" parameter specifies whether the "Value 1 for falling edge" or the"Value 2 for falling edge" is sent out for falling edge.Alternatively, Value1/Value2 can also be alternatingly set for a rising edge, i.e. after Value 1was sent (or received), a renewed operation will send out Value 2. After it is operated again,Value 1 is again sent out.The values 1 and 2 are specified via the parameters "Value 1" and "Value 2".The "No reaction" setting causes no telegram to be sent out for a operation of the button.10.7.3 Extended parameters - Reaction on rising edgeOptions: No reactionValue 1Value 2Alternating value1/value2The application can differentiate between the operation and the releasing of the button. Anoperation is designated as "Rising edge" and the releasing is designated as "Falling edge".The application "1-button value transmitter" makes two separate "Switching" communicationobjects available for the left or right side of the button. The value 1 is always sent out on the firstobject (Value 1) and the value 2 is always sent out on the second object (Value 2).The "Reaction to rising edge" parameter specifies whether the "Value 1 for rising edge" or the"Value 2 for rising edge" is sent out for rising edge.Alternatively, Value1/Value2 can also be alternatingly set for a rising edge, i.e. after Value 1was sent (or received), a renewed operation will send out Value 2. After it is operated again,Value 1 is again sent out.The values 1 and 2 are specified via the parameters "Value 1" and "Value 2".The "No reaction" setting causes no telegram to be sent out for a operation of the button.
