41GRAND TOTAL PRESETThe Grand Total is located at the bottom of your "Z" Report. The Grand Total is the only figure that does not resetback to zero after taking a "Z" Report. It is commonly known as the "running grand total". However, if you wish,you can reset the Grand Total to zero or assign it a specific value. The procedure used to assign a value to theGrand Total may be helpful after a Full System Clear is performed; since it automatically resets the Grand Totalback to zero.TO SET THE GRAND TOTAL TO ZEROThe Grand Total can be a maximum of 12 digits. When clearing the Grand Total, it is recommended to followthese steps to reset the total to zero."PRG" + (777777) + [AMOUNT TEND/TOTAL] + (0) + [NON TAX]NOTE: It is recommended to take a "Z" reading prior to setting the Grand Total to zero.1. Turn the key to the "PRG" (PROGRAM) position.2. If a Manager Password has been programmed, ENTER the (PASSWORD #), then PRESS the [CLERK]key, or if you did not program a Manager Password, go to Step 3.3. ENTER (777777), PRESS the [AMOUNT TEND/TOTAL] key, ENTER (0), then PRESS the [NON TAX]key.TO ASSIGN A VALUE TO THE GRAND TOTAL"PRG" + (777777) + [AMOUNT TEND/TOTAL] + (Assigned Value) + [NON TAX]12 digits (maximum)Example: Set the Grand Total for $15,000.00:1. Turn the key to the "PRG" (PROGRAM) position.2. If a Manager Password has been programmed, ENTER the (PASSWORD #), then PRESS the [CLERK]key, or if you did not program a Manager Password, go to Step 3.3. ENTER (777777) then PRESS the [AMOUNT TEND/TOTAL] key.4. ENTER (1500000) then PRESS the [NON TAX] key.
