DigitalTalk® EXPRESSPhone Adapter1. An active wired internet connection with a minimum download andupload speed of 128 Kbps per voice line2. Your existing telephone equipment3. Access to an open port on your router with wired Ethernet cablePhone Adapter Installation GuideCongratulations on the purchase of your new ACN DigitalTalk® Express Phone Adapter!It is important to read all instructions in their entirety. If you are unfamiliar with your currenttelephone equipment setup, please consult a local qualified telecom technician.REVIEW ITEMS INCLUDED IN YOUR PHONE ADAPTER KIT Items You NeedITEMS YOU NEEDAC Adapter Ethernet CableACN Phone AdapterSTEP 1 CONNECTING THE PHONE ADAPTER TO YOUR INTERNET1. Place the phone adapter where your service provider phone lines connect to your phone wiring. Thisis typically in a wiring closet or panel.2. Connect one end of the Ethernet cable to an available port on your router with the other endconnected to the port on the phone adapter labeled LAN.3. Connect the AC adapter to the back of the phone adapter in the port labeled DC 12V. Plug the otherend into an outlet.4. Wait 7 minutes for the phone adapter to initially register with ACN’s network.5. Verify that the phone adapter is properly connected by noting the LED status lights.Confirm the following lights are on:• Power• LAN (back of phone adapter)• Phone (one light per line)If for any reason the lights indicated above are not on, reference the LED StatusIndicator Table in this guide.LED STATUS INDICATOR TABLEDevice LED LED Status Reason for LED StatusPower ON Device has powerOFF Device does not have powerEthernet/RJ45(back of adapter)ON Establish Ethernet Cable/ConnectionOFF Failure in Ethernet Cable/ConnectionPhoneON Ready to make/ recieve callsOFF Line not ready/availableBlinking New Voice Mail message