ACP HDC Series Owner's Manual

ACP HDC Series Owner's Manual Manual pdf 16 page image

©2019 ACP, Inc.Cedar Rapids, IA 52404Page 16 of 22Part No. 20267401Original InstructionsCooking DisplaysSTYLE 2 STYLE 3 DESCRIPTIONREADY READY Displays when oven control will accept entries00:00 00:00 Displays cooking time. If stage cooking is programmed, total cooking time is displayed% MW POWER COOK LEVELDisplays while oven is operating to show the percent microwave power level.• Style 2: The % MW Power is displayed about as a number 10-90 in intervals of 10. If nonumber is displayed, the oven is cooking at full power.• Style 3: The cooking level is displayed above as a number 1 through 9. (1=10%, 2=20%,3=30%, etc.) If no number is displayed, the oven is cooking at full power.COOKING POWER Displays while the oven is generating microwave energy during a cooking cycle.Programming DisplaysSTYLE 2 STYLE 3 DESCRIPTIONPROGRAM PROGRAM Displays when entering programming mode.P0- P:0 Displays when oven enters programming mode for single digit keypad memory only.P-- P: Displays when oven enters programming mode for double digit keypad memory. 2 keypadsmust be pressed to enter a program.OPTIONS OP:-- Displays when oven is in user option mode. User options can then be set or specified.cf:0- CF: Displays with a numerical cooking factor when the X2 keypad is pressed. Cooking Factoris the percentage by which cooking time increases when using X2 keypad to cook multipleportions. (1=10%, 2=20%, 3=30%, etc.)stage- P:--1 Number (1 through 4) indicates the stage that is being programmed.• Style 2: The stage # is displayed above cooking time.• Style 3: The stage # displays briefly when programming a specific cooking stage.Interrupting OperationWhile the oven is operating, press STOP/RESET keypad tointerrupt operation. Display shows remaining cooking time.Close door and press START key to resume oven operation.Canceling MistakesIf oven is not cooking, press STOP/RESET keypad to cleardisplay. If oven is cooking, press STOP/RESET keypad onceto stop oven, then again to clear display. If oven door is openand time shows in display, close oven door and press STOP/RESET keypad to clear display.Factory Preset ProgramsAll preprogrammed keypads arrive set at full power (100%).KEYPAD TIME KEYPAD TIME1 10 sec. 6 1:30 min.2 20 sec. 7 2:00 min.3 30 sec. 8 3:00 min.4 45 sec. 9 4:00 min.5 1:00 min. 0 5:00 min.Note: Factory setting may vary by modelSTYLES 2 & 3 Displays and OperationOperating Preset Program KeypadsFrom the factory, this oven comes preprogrammed withseveral cooking sequences in memory.Note: To change single or double keypad entry option see“User Options” section in this manual.1. Open oven door and place food in oven. Close door.• Display shows “READY”2. Select the keypad(s) for the desired preprogrammedcooking sequence.• Single Digit Keypad Cooking: press a keypad (0-9)• Double Digit Keypad Cooking: press the two keypads,in order, of the double digit number for the desiredcooking sequence.(00-99)3. Oven begins cooking and displays remaining cookingtime.4. If additional cooking time is required, press presetprogram keypad(s) before or after cooking cycle ends.5. At the end of the cooking cycle, the oven beeps. Carefullyremove food from oven.