ACR Electronics AIS Link MOB User Manual

Contents

MOB USER MANUAL11 Y1-03-0283 Rev. CB2. Load the fixing buckle with the activation tape as shown below.B3. Bond the fixing buckle to the fixing buckle patch. Ensure that the two ears of the ‘T’are positioned on the side of the patch without the adhesive. This will ensure that whenthe buckle is tensioned it cannot be pulled through the adhesive patch.B4. Adhere the fixing buckle patch assembly to an appropriateposition on the bladder in line with the activation slide.B5. Follow the steps indicated previously in Section 3 toattach the activation tape to the activation slide, rewindthe antenna (section 6), and finally re-insert theactivation slide back in-between the two arming retainers.NOTE: The reflective patches are not intended for longterm external exposure. Patches will need inspecting andpossible replacement following a deployment.C. Installation bracket attachment onto jacket with separate bladder:C1. Thread a reflective strip, with the protective backing removed, through the slots onthe installation bracket. Attach the bracket to the product and position in the desiredlocation on the bladder. Be sure to press down on the reflective strip in order toadhere it securely to the bladder. Now remove the product from the bracket and