www.acti.comInstallation Guide26How to Connect a Power Adapter (Optional)In case of using a non-PoE switch or your PoE switch has limited power supply, you canpurchase a power adapter and directly connect the camera to a power outlet. The power adaptermust be connected to the supplied terminal block before use.To do this, follow the procedures below:1. Loosen the screws of the 12V and GND pins of the power terminal block.2. Take note that a standard power adapter cable has two (2) different wires:White stripe: Connects to 12V PinConnects to GND Pin

Installation Procedures

Step 1: Prepare for Waterproof Installation

Step 2: Prepare the Camera for Installation

Step 3: Install the Gang Box

Step 4: Install the Gang Box Converter

Step 5: Connect the Cable(s)

Waterproof Solution with Conduit

Step 6: Install the Camera

Step 7: Connect to Network

Step 9: Close the Dome Cover

Appendices

How to Connect a Power Adapter (Optional)

How to Connect DI/DO Devices (Optional)

How to Connect Audio Devices (Optional)

Safety Information

ACTi KCM-7911 Installation Manual

Precautions

Introduction

Features and Benefits

Safety Instructions

Physical description

Product Specification

Installation Procedure

How to Do the Waterproof Installation

Accessing Camera

KCM-7911

Physical Description

Installing the Camera on a Flat Surface

Step 2: Open the Camera Cover

Step 3: Prepare for Waterproof Installation

Step 6: Close the Cover

Waterproof Solutions

Other Connections

Connecting DI/DO Devices (Optional)

Connecting Audio In / Out Devices (Optional)

Configure the IP Addresses

Access the Camera

Mounting Solutions

Installation Procedures using Naked Cable

Step 2: Attach the Tilted Mount

Step 4: Open the Camera Cover

Step 6: Install the Camera to the Tilted Mount

Step 7: Close the Cover

Installation Procedures using Flex Conduit

Step 4: Prepare for Waterproof Installation

installation guide

Step 5: Install the Camera to the Tilted Mount

safety information