ADJ COB CANNON WASH DW User Manual

18A D J R F C O P E R A T I O NThe ADJ RFC remote (sold seperately) has many different functions and allows you to controlyour COB Cannon Wash DW remotely. To use the RFC remote, you must first activate the fixture’sreceiver, as described in the Operating Instructions section of this manual. Maximum range is 150ft. Please note that the fixture will only respond to remote inputs when set to Primary mode.BLACKOUT - Pressing this button will blackout the fixture. Press and hold for 3 seconds to activatedefault mode. All modes will return to their default settings.AUTO RUN - This button cycles through color fade mode, color change mode, and auto run mode.Each button press cycles the fixture to the next mode. Color fade mode and color change mode eachhave 8 selectable programs, which can by cycled using the “+” and “-” buttons. To adjust the speedof the selected mode, press the SPEED button and then use the “+” and “-” buttons to make adjust-ments.SELECTION PROGRAM - Press this button to activate Static Color mode. Use the “+” and “-” buttonsto scroll through the 8 colors. Once you have found your desired color, press the FLASH button toactivate strobing, then use the “+” and “-” buttons to adjust the strobe speed.FLASH - This button will activate the flash (strobe) effect. You can control the flash speed by pressingthe “+” and “-” buttons.SPEED - Press this button and use the “+” and “-” buttons to adjust the speed of the color fade mode,color change mode, and auto run.SOUND ACTIVE - This button activates sound active mode. Use the “+” and “-” buttons to scrollthrough the 8 sound active modes. Press the SOUND ACTIVE button again to access sound sensitiv-ity adjustment. Use the “+” and “-” buttons to adjust the sound sensitivity level.R G - Press the “R” button to access Warm White or “G” to access Cold White. Use the “+” and “-”buttons to adjust the brightness. Press the Flash button to activate strobing and use the “+” and “-”buttons to adjust the strobe speed.“+” and “-” - These buttons are used to adjust the flash rate, auto run speed, color fade speed, colorchange speed, sound sensitivity, and output intensity. These buttons are also used to scroll throughthe static colors, color fade modes, color change modes, and sound active modes.