ADJ FOCUS BEAM LED User Instructions

Also see for FOCUS BEAM LED: User instructions

Contents

ADJ Products, LLC - www.adj.com - Focus Beam LED User Manual Page 5Focus Beam LED Safety Precautions• DO NOT TOUCH the fixture housing during operation. Turn OFF the power and allow approximately15 minutes for the fixture to cool down before servicing.• DO NOT shake the fixture, avoid brute force when installing and/or operating the fixture.• DO NOT operate the fixture if the power cord has become frayed, crimped and/or damaged. If thepower cord is damaged, replace immediately with a new one of similar power rating.• DO NOT Do not attempt to remove or break off the ground prong from the electrical cord. Thisprong is used to reduce the risk of electrical shock and fire in case of an internal short.• DO NOT attempt to operate this unit, if it becomes damaged.• DO NOT spill water or other liquids into or on to your unit.• This unit is intended for indoor use only, use of this product outdoors voids all warranties.• To reduce the risk of electrical shock or fire, do not expose this unit rain or moisture• Disconnect from main power before making any type of connection.• DO NOT block any air ventilation slots. All fan and air inlets must remain clean and never blocked.Allow approx. 6” (15cm) between fixture and other devices or a wall for proper cooling.• Always be sure to mount this unit in an area that will allow proper ventilation. Allow about 6”(15cm) between this device and a wall.• During the initial operation of this fixture, a light smoke or smell may emit from the interior of thefixture. Thsi is a normal process and is caused by excess paint in the interior of the casing burningoff from the heat. This will decrease gradually over time.• DO NOT remove the cover under any conditions. There are no user serviceable parts inside.• When installing fixture in a suspended enviroment, always use mounting hardware that is no lessthan M10 x 25mm, and always install fixture with an appropriately rated safety cable.• Never operate this unit when it’s cover is removed.• Never plug this unit in to a dimmer pack• During long periods of non-use, disconnect the unit’s main power.• Always mount this unit in safe and stable matter.• Power-supply cords should be routed so that they are not likely to be walked on or pinched byitems placed upon or against them, paying particular attention to the point they exit from the unit.• Cleaning -The fixture should be cleaned only as recommended by the manufacturer. See page 25for cleaning details.• Heat -The appliance should be situated away from heat sources such as radiators, heat registers,stoves, or other appliances (including amplifiers) that produce heat.• The fixture should be serviced by qualified service personnel when:A. The power-supply cord or the plug has been damaged.B. Objects have fallen, or liquid has been spilled into the fixture.C. The fixture has been exposed to rain or water.D. The fixture does not appear to operate normally or exhibits a marked change in performance.E. The fixture has fallen and/or subjected to extreme handling.