ADJ FOCUS BEAM LED User Instructions

Also see for FOCUS BEAM LED: User instructions

Contents

ADJ Products, LLC - www.adj.com - Focus Beam LED User Manual Page 8Focus Beam LED InstallationScrew one clamp each via a M12 screw and nut into the Omega bracket. Insert the quick-lock fastenersof the Omega holder’s into the respective holes on the bottom of the Focus Beam LED. Tighten thequick-lock fasteners fully clockwise. Always use and install the supplied safety cable as a safetymeasure to prevent accidental damage and/or injury in the event the clamp fails. Pull the safetycable through the openings located on the base plate and over the trussing system or a safe fixationspot. Insert the end in the carabine and tighten the safety screw. Note: Never use the carrying handlesfor secondary attachment.NOTICE: When installing the unit, the trussing or area of installation must be able to hold 10 timesthe weight without any deformation. The suitable enviromental temperature for this lighting fixture isbetween -25˚ C to 45˚ C. Do not place this lighting fixture in an enviroment where the temperaturesare under or above the temperatures stated above. This will allow the fixture to run at its best andhelp prolong the fixture life. Be sure this fixture is kept at least 12m (40ft) away from any flammablematerials (decoration etc.).SAFETY CABLERIGGING POINTOMEGA BRACKETATTACHMENT POINTS