ADJ HYDRO BEAM X1 User Instructions

Also see for HYDRO BEAM X1: User manual

ADJ Products, LLC - www.adj.com - Hydro Beam X1 User Manual Page 6Hydro Beam X1 Safety GuidelinesFOR YOUR OWN PERSONAL SAFETY, PLEASE READ AND UNDERSTAND THIS MANUAL COMPLETELYBEFORE YOU ATTEMPT TO INSTALL OR OPERATE THIS UNIT!• THERE ARE NO USER SERVICEABLE PARTS INSIDE THIS UNIT. DO NOT ATTEMPT ANY REPAIRSYOURSELF; DOING SO WILL VOID YOUR MANUFACTURES WARRANTY. DAMAGES RESULTING FROMMODIFICATIONS TO THIS FIXTURE AND/OR THE DISREGARD OF SAFETY INSTRUCTIONS ANDGUIDELINES IN THIS MANUAL VOID THE MANUFACTURES WARRANTY AND ARE NOT SUBJECT TOANY WARRANTY CLAIMS AND/OR REPAIRS.• DO NOT PLUG THE FIXTURE INTO A DIMMER PACK!NEVER OPEN THIS FIXTURE WHILE IN USE!UNPLUG POWER BEFORE SERVICING FIXTURE!NEVER TOUCH THE FIXTURE DURING OPERATION AS IT MAY BE HOT!KEEP FLAMMABLE MATERIALS AWAY FROM FIXTURE!• ENSURE ALL CONNECTIONS AND END CAPS ARE PROPERLY SEALED WITH A DIELECTRIC GREASE(AVAILABLE AT MOST ELECTRICAL SUPPLIERS) TO PREVENT WATER CORROSION AND/ORELECTRICAL SHORT CIRCUIT.• IF THE FIXTURE IS EXPOSED TO ENVIRONMENTAL TEMPERATURE CHANGES SUCH AS RELOCATIONFROM AN OUTDOOR COLD TO AN INDOOR WARM ENVIRONMENT, DO NOT POWER THE FIXTUREON IMMEDIATELY. INTERNAL CONDENSATION AS A RESULT OF ENVIROMENTAL TEMPERATURECHANGE CAN CAUSE INTERNAL FIXTURE DAMAGE. LEAVE THE FIXTURE POWERED OFF UNTIL IT HASREACHED ROOM TEMPERATURE BEFORE POWERING ON.• NEVER LOOK DIRECTLY INTO THE LIGHT SOURCE! RETINA INJURY RISK - MAY INDUCE BLINDNESS!SENSITIVE PERSONS MAY SUFFER AN EPILEPTIC SHOCK!• Be sure that the local power outlet is compatible with the required voltage for your unit.• Do not attempt to operate this unit if the power cord has been frayed or broken.• Do not attempt to remove or break off the ground prong from the electrical cord. This prong is used toreduce the risk of electrical shock and fire in case of an internal short.• Disconnect from main power before making any type of connection.• Do not remove the cover under any conditions. There are no user serviceable parts inside.• Never operate this unit when it’s cover is removed.• Always be sure to mount this unit in an area that will allow proper ventilation. Allow about 6” (15cm)between thisdevice and a wall.• Do not attempt to operate this unit, if it becomes damaged.• Always mount this unit in safe and stable matter.• Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placedupon or against them, paying particular attention to cords at plugs, convenience receptacles, and the pointwhere they exit from the appliance.• Cleaning -The fixture should be cleaned only as recommended by the manufacturer. See page 38 for cleaningdetails.• Heat -This fixture should be situated away from heat sources such as radiators, heat registers, stoves, or otherappliances (including amplifiers) that produce heat.• The fixture should be serviced by qualified service personnel when the appliance does not appear to operatenormally or exhibits a marked change in performance.