ADJ IKON PROFILE WW User Manual

Also see for ikon profile ww: User instructions

ADJ Products, LLC - www.adj.com - Ikon Profile WW User Manual Page 7On-Board System Menu. The Ikon Profile WW comes with an easy to navigate system menu. Thisnext section will detail the functions of each command in the system menu. Please read the nextsection thoroughly!To access the main menu press the MENU button. Press the UP or DOWN buttons until you reachthe desired function, press the ENTER button to select. Once a function is selected, use the UP orDOWN buttons to change the function settings. Once your changes are made press the ENTERbutton, and then press and hold the MENU button for at least three seconds to confirm and lock thechange into the system memory. If the MENU button is not pressed and held within eight seconds,the fixture will automatically confirm and lock the change into the system memory. To exit withoutmaking any changes press the MENU button.ADDR - DMX Address Setting1. Press the MENU button until “ADDR” is displayed, and press ENTER.2. The current DMX address will now be displayed and flashing. Press the UP or DOWN buttons tofind your desired address. Press ENTER to set your desired DMX address.NOTE: If after you connect your DMX controller the unit does not fall into DMX mode, press and holdthe MENU button for at least 3 seconds.SCND - This will let you set unit as a primary or secondary in a primary/secondary configura-tion.1. Press the MENU button until “SCND” is displayed, and press ENTER. “Prl” or “SEC” will be dis-played.2. Press the UP or DOWN buttons until your desired setting is displayed, press ENTER to confimand exit.DNST - This mode defines how the fixture will behave in the event that DMX communication islost or interrupted.1. Press the MENU button until “DNST” is displayed, and either “Pr Se”, “BLND”, or “LAST” will bedisplayed beneath.2. Press ENTER and the bottom choice will begin to flash. Use the UP or DOWN buttons to choosean operating mode you would like the unit to start up in when power is applied or the DMX signalis lost.• PrSe (Primary-Secondary) - If the DMX signal is lost or power is applied, the unit will auto-matically go into Primary/Secondary mode and run a built-in show.• BLND (Blackout) - If the DMX signal is lost or interrupted, the unit will automatically go intostand by mode.• LAST - If the DMX signal is lost the fixture will stay in the last DMX setting. If power is ap-plied and this mode is set, the unit will automatically go into the last DMX set up.3. Press ENTER to confirm your desired set up.Ikon Profile WW System Menu