ADJ Ikon Profile User Instructions

Also see for Ikon Profile: User instructions

Contents

fixture cleaning

ADJ Products, LLC - www.adj.com - Ikon Profile User Manual Page 7ADJ Products, LLC - www.adj.com - Ikon Profile User Manual Page 6On-Board System Menu. The Ikon Profile comes with an easy tonavigate system menu. This next section will detail the functions ofeach command in the system menu. Please read the next sectionthoroughly!To access the main menu press the MENU button. Press the UP orDOWN buttons until you reach function you wish to change. Whenyou reach the function you wish to change press the ENTER button.When a function is selected use the UP or DOWN buttons to changethe function settings. Once your changes are made press the ENTERbutton, and then press and hold the MENU button for at least threeseconds to confirm and lock the change into the system memory. Ifthe MENU button is not pressed and held within eight seconds thefixture will automatically confirm and lock the change into the systemmemory. To exit without making any changes press the MENU button.ADDR - DMX Address Setting.1. Press the MENU button until “ADDR” is displayed, pressENTER.2. The current DMX address will now be displayed and flashing.Press the UP or DOWN buttons to find your desired address.Press ENTER to set your desired DMX address.NOTE: If after you connect your DMX controller the unit doesnot fall into DMX mode, press and hold the MENU button for atleast 3 seconds.SLND - This will let you set unit as a master or slave ina master/slave configuration.1. Press the MENU button until “SLND” is displayed, pressENTER. “MAST” or “SL 1” will be displayed.2. Press the UP or DOWN buttons until your desired setting isdisplayed, press ENTER to confim and exit.DNST - This mode can be used as a precaution mode,that in case the DMX signal is lost, interrupted, or power islost, the operating mode chosen in the setup is the runningmode the fixture will go into when the DMX signal is lost. Youcan also set this as the operating mode you would like theunit to return to when power is applied.1. Press the MENU button until “DNST” is displayed, and either“MASL”, “BLND”, or “LAST” will be displayed beneath.2. Press ENTER and the bottom choice will begin to flash. Usethe UP or DOWN buttons to choose an operating mode youwould like the unit to start up in when power is applied or theDMX signal is lost.• MASL (Master Slave) - If the DMX signal is lost or power isapplied, the unit will automatically go into Master Slave modeand run a built-in show.• BLND (Blackout) - If the DMX signal is lost or interrupted, theunit will automatically go into stand by mode.• LAST - If the DMX signal is lost the fixture will stay in the lastDMX setting. If power is applied and this mode is set, the unit willautomatically go into the last DMX set up.3. Press ENTER to confirm your desired set up.DIND - This will let select your desired dimmer curve.1. Press the MENU button until “DIND” is displayed, and pressENTER. 1 of 5 dimmer curves will be displayed. “STDA” (stan-dard), “STGE” (stage), “TV” (TV), “ARAL” (Architectural), or“THAL” (Theatre). See the dimmer curve chart on page 28 formore info.2. Press the UP or DOWN buttons to find your desired dimmercurve and press ENTER to confim and exit.Ikon Profile System Menu Ikon Profile System Menu