ADJ ULTRA HEX PAR3 User Instructions

Contents

Ultra Hex Par3 Operating Instructionsbutton until “don” is displayed, press the UP button to display “doff”.Now the display will disappear after 20s. Press any button to turn thedisplay on again. Be advised though that the display will turn off auto-matically after 20 seconds.To set the display press the MODE button until “dXX” is displayed.Use the UP or DOWN buttons to select either:“don” = LED display on at all times.“doFF” = LED display shuts off after 20 seconds.ADJ RFC:This function is used to activate and deactivate the ADJ RFC (RemoteControl). When this function is activated you can control the fixtureusing the ADJ RFC. Please see the next page for ADJ RFC controlsand functions.1. Plug the fixture in and press the MODE button until “dXX” is dis-played. “XX” represents either “on” or “oFF”.2. Press the SET UP button until “rFXX” is displayed. “XX” repre-sents either “on” or “oF”.3. Press the UP or DOWN buttons to either activate the remote func-tion (On) or deactivate it (Off).LED Display Inversion:Follow these instructions to flip the display 180° so that the displaycan be read upside down.1. Plug the fixture in and press the MODE button until “dXX” is dis-played. “XX” represents either “on” or “oFF”.2. Press the SET UP button until either “Stnd” or “rEv” is displayed.3. Press the UP or DOWN buttons to reverse the display 180°.Default Running Mode:This is a default running mode. When this mode is activated all modeswill return to their default settings.1. Plug the fixture in and press the MODE button until “dXX” is dis-played. “XX” represents either “on” or “oFF”.2. Press the SET UP button until “dEFA” is displayed.3. Press the UP and DOWN buttons simultaneously. Press theMODE button to exit.ADJ Products, LLC - www.adj.com - Ultra Hex Par3 User Manual Page 11ADJ Products, LLC - www.adj.com - Ultra Hex Par3 User Manual Page 10Dimmer Curve:This is used to set the dimmer curve used with DMX mode.1. Plug the fixture in and press the MODE button until the DMXaddress is displayed.2. Press the SET UP button until “dr-X” is displayed. This is the dim-mer setting. “X” represents the dimming mode.3. Use the UP and DOWN buttons to find your desired dimmercurve. Press SET UP when you are finished.DMX State:This mode can be used as a precaution mode, that in case the DMXsignal is lost, the operating mode chosen in the setup is the runningmode the fixture will go into when the DMX signal is lost. You can alsoset this as the operating mode you would like the unit to return to whenpower is applied.1. Press the MODE button until the DMX address is displayed. Pressthe SET UP button until “No-X” is displayed.2. “X” represents a number between 0-2. Choose an operating modeyou would like the unit to start up in when the DMX signal is lostor interrupted.• “No-0” (Blackout) - If the DMX signal is lost or interrupted, the unit willautomatically go into stand by mode.• “No-1” (Last State) - If the DMX signal is lost or interrupted, the fixturewill stay in the last DMX set up. If power is applied and this mode is set,the unit will automatically go into the last DMX set up.• “No-2” (Auto Run) - If the DMX signal is lost or interrupted, the unit willautomatically go into Auto Run mode.3. Press SET UP to confirm your desired set up.Ultra Hex Par3 Operating Instructions