ADJ ULTRA HEX PAR3 User Instructions

Contents

ADJ Products, LLC - www.adj.com - Ultra Hex Par3 User Manual Page 13ADJ Products, LLC - www.adj.com - Ultra Hex Par3 User Manual Page 12Master-Slave Configuration:This function will allows you to link units together to run in a Master-Slave mode. In Master-Slave operation one unit will act as the con-trolling unit and the others will react to the controlling units built-inprograms. Any unit can act as a Master or as a Slave however, onlyone unit can be programmed to act as the “Master.”Master-Slave Connections and Settings:1. Daisy chain your units via the XLR connector on the rear of theunit. Use standard XLR data cables to link your units together.Remember that the Male XLR connector is the input and theFemale XLR connector is the ouput. The first unit in the chain(master) will use the female XLR connector only. The last unit inthe chain will use the male XLR connector only.2. Set the “Master” unit to your desired mode of operation.3. Connect the first “Slave” unit to the “Master.”4. On the “Slave” unit press the MODE button until “SLAv” is dis-played. The “Slave” unit will now follow the “Master”.Ultra Hex Par3 Master-Slave ConfigurationWith this feature you can connect the fixtures to one anotherusing the IEC input and output sockets. The quantity that can beconnected is 20 fixtures maximum. After 20 fixtures you will needto use a new power outlet. They must be the same fixtures. DONOT mix fixtures.Ultra Hex Par3 Power Cord Daisy ChainThe ADJ RFC remote (sold seperately) has many different functions and al-lows you to control your Ultra Hex Par3 from long distance. The ADJ RFCremote can control your system up to 150 ft. To use the RFC you must firstactivate the fixtures receiver, to activate the receiver please see the instruc-tions on page 10.BLACKOUT - Pressing this button will blackout the fixture.AUTO RUN - This button will run 1 of 3 auto run programs. Each pressof the button will scroll through Color Fade, Color Change, and Random.When you activate Color Fade, you can use the “+” and “-” buttons to scrollthrough the 16 different color fade modes. When you activate Color Change,you can use the “+” and “-” buttons to scroll through the 16 different colorchange modes. You can control the fade speed and color change speed ofthe Auto Run by pressing the speed button and then adjust the speed usingthe “+” and “-” buttons.PROGRAM SELECTION - This button will activate Static Color mode.Press this button to activate Static Color mode. Use the “+” or “-” to scrollthrough the 63 colors. Once you have found your color, you can press theFlash Button to activate strobing and use the “+” or “-” to adjust the Flashrate.FLASH - This button will activate the flash (strobe) effect. You can controlthe flash speed by pressing the “+” and “-” buttons.SPEED - Press this button and use the “+” & “-” buttons to adjust the speedof the Built-In Programs.SOUND ACTIVE - This button activates sound active mode. Use the “+” &“-” buttons to scroll through the 16 sound active modes. Press this buttonagaing to switch to sound sensitivity adjustment and then use the “+” & “-”buttons to adjust the sound sensitivity level.R G B W/A - Press either one of these buttons and the press the “+” or “-”to adjust the brightness. Press the Flash button to activate strobing and usethe “+” or “-” buttons to adjust the strobe speed.NOTE: Press the W/A button to scroll through White, Amber, and UV.“+” and “-” - Use these buttons to adjust the flash rate, speed of the AutoRun, fade speed, sound sensitivity, and output intensity. Use these buttonsto scroll through the static colors.Ultra Hex Par3 ADJ RFC OperationUltra Hex Par3 Photometric Chart