Command Reference Guide Global Configuration Mode Command Set61200510L1-35E Copyright © 2005 ADTRAN 324GLOBAL CONFIGURATION M ODE C OMMAND S ETTo activate the Global Configuration mode, enter the configuration command at the Enable Securitymode prompt. For example:>enable#configure terminal(config)#The following commands are common to multiple command sets and are covered in a centralized sectionof this guide. For more information, refer to the sections listed below:cross-connect <#> on page 28description on page 31do on page 32end on page 33exit on page 34shutdown on page 35All other commands for this command set are described in this section in alphabetical order.aaa accounting commands begin on page 327aaa authentication commands begin on page 330aaa authorization commands begin on page 336aaa group server [radius | tacacs+] on page 338aaa on on page 340aaa processes on page 342arp arpa on page 343auto-config [filename | restart | retry-count | server ] onpage 344banner [exec | login | motd] on page 346boot config [cflash | flash] [cflash | flash] on page 347boot system flash [no-backup | ] on page 348bridge protocol ieee on page 349clock [auto-correct-dst | no-auto-correct-dst] on page 350clock set on page 351clock timezone on page 352cross-connect <#> onpage 355
