Command Reference Guide E1 Interface Configuration Command Set61200510L1-35E Copyright © 2005 ADTRAN 596E1 INTERFACE C ONFIGURATION C OMMAND S ETTo activate the E1 Interface Configuration mode, enter the interface e1 command (and specify the E1port) at the Global Configuration mode prompt. For example:>enable#configure terminal(config)#interface e1 1/1(config-e1 1/1)#The following commands are common to multiple command sets and are covered in a centralized sectionof this guide. For more information, refer to the sections listed below:alias <“text”> on page 27cross-connect <#> on page 28description on page 31do on page 32end on page 33exit on page 34shutdown on page 35All other commands for this command set are described in this section in alphabetical order.clock source [internal | line | through] on page 597coding [ami | hdb3] on page 598framing [crc4] on page 599loop-alarm-detect on page 600loopback network [line | payload] on page 601loopback remote v54 on page 602remote-alarm [rai | ais] on page 603remote-loopback on page 604sa4tx-bit [0 | 1] on page 605show test-pattern on page 606snmp trap line-status on page 607snmp trap link-status on page 608snmp trap threshold-reached on page 609tdm-group timeslots <1-31> speed [56 | 64] on page 610test-pattern [clear | insert | ones| p215 | p220 | p511 | qrss | zeros] on page 611ts16 on page 612
