ADTRAN 1700595G10 Quick Start Manual

Quick Start Guide, 61700595G10-13B, March 2015 1NET VANTA 1235P ACTIVREACH ETHERNET S WITCHP/N 1700595G10GETTING STARTEDTwo configuration methods are available for your NetVanta unit:• Web-based graphical user interface (GUI)• ADTRAN Operating System (AOS) command line interface (CLI)The GUI lets you configure the main unit settings and provides online guidance and explanationsfor each setting. However, using the AOS CLI may be necessary for more advancedconfigurations.ACCESS THE GUIYou can access the GUI from any web browser on your network by following these steps:1. Connect the unit to your PC using any of the ports on the front of the unit and an Ethernetcable.2. Set your PC to a fixed IP address of 10.10.10.2. To change your PC IP address, navigate toComputer > Control Panel > Network Connections > Local Area Connection >Properties > IP (TCP/IP) and select Use this IP Address. Enter these parameters:IP Address: 10.10.10.2Subnet Mask: 255.255.255.0Default Gateway: 10.10.10.1You do not need to enter any domain naming system (DNS) server information. After theinformation is entered, select Ok twice, and close the Network Connections dialog box. Ifyou cannot change the PC’s IP address, you will need to change the unit’s IP address usingthe CLI. (Refer to the next two sections for instructions.)3. Open a Web browser and enter the unit’s IP address in your browser address line as follows:http://10.10.10.1. The default IP address is 10.10.10.1, but if you had to change the unit’s IPaddress using the CLI, enter that address in the browser line.4. You will then be prompted for the user name and password (the default settings are adminand password).5. The initial GUI screen appears. You can access initial setup information by selecting SetupWizard from the menu on the left.ACCESS THE CLIAccess the AOS CLI via the CONSOLE port, Telnet, or SSH session. To establish a connection tothe NetVanta unit CONSOLE port, you need the following items:• PC with VT100 terminal emulation software• Straight-through serial cable with a DB-9 (male) connector on one end and the appropriateinterface for your terminal or PC communication port on the other end1. Connect the DB-9 (male) connector of your serial cable to the CONSOLE port located oneither the front or the rear panel depending on the unit.2. Connect the other end of the serial cable to the terminal or PC.There are many terminal emulation applications available on the web.PuTTY, SecureCRT, and HyperTerminal are a few examples.

/ 4

Related manuals for ADTRAN 1700595G10