6 Issue 2, December 2004 61180403L1-5BFigure 2. DIP Switches DetailSoftware ProvisioningThe FXS/DPO is provisioned by connecting a VT100terminal or a computer running a terminal emulationprogram to the craft interface ADMIN port located on theSystem Controller Unit (SCU) front panel. Connectionto the port is made via a RS-232, DB-9 cable with amale connector.Craft port settings are as follows:ï 9600 Baudï No parityï 8 Data bitsï 1 Stop bitï No Flow ControlThe provisioning options for the FXS/DPO accessmodule are described in the following tables:ï Table 5, FXS/DPO General Options on page 7ï Table 6, FXS/DPO Mode Options on page 8ï Table 7, FXS/DPO Tandem Options on page 9Password and User IDPassword protection is a function of the SCU and isfactory disabled. If password authentication is enabled,then the SCU will display the Logon screen. A validUser Name and Password are required to access themenus.The default User Name is ìuserî, and the defaultPassword is ìpasswordî. The User Name and Passwordare not case sensitive.Menu NavigationTo traverse through the menus, select the desired entry,and press E NTER. To work backward in the menu, pressthe E SC (escape) key.The menu tree in Figure 3 on page 10 illustrates thepath to every provisioning, performance, and test accesspoint in the Total Access 1500 FXS/DPO menuON1 2 3 4 5 6 7 8SD08C & KON1 2 3 4 5 6 7 8SD08C & KON1 2 3 4 5 6 7 8SD08C & KON1 2 3 4 5 6 7 8SD08C & KD3MODE 1MODE 2GSAUTO_TERM900RTGDTGDPCRX64RX32RX16RX08RX04RX02RX01SDTX64TX32TX16TX08TX04TX02TX01IMMREVNB64NB32NB16NB08NB04NB02SW4SW3SW2SW1WINKNORMOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFD4OFFOFFLSOFF600OFFOFFSwitches SW1 through SW4 are used to select/deselect a particular ìStateî vice the labeled switch nomenclature of on/off.