ADTRAN NetVanta 3200 series Hardware Installation Manual

Also see for NetVanta 3200 series: Hardware installation guide Quick reference guide Hardware installation guide Hardware installation guide Hardware installation guide

Contents

ADTRAN NetVanta 3200 series Hardware Installation Manual Manual pdf 74 page image

Unit Installation NetVanta 3200/3300/3400 Series74 Copyright © 2012 ADTRAN, Inc. 61200860L1-34ABInstalling Dial Backup and Network Interface ModulesThe DIMs plug onto the NIMs. The NIMs are then installed in the rear panel option module slot. Thefollowing tables list the installation steps. Also, see Figure 36 on page 74 and Figure 37 on page 75.Figure 36. Installing DIMsFor NetVanta modules with outside plant connections, ensure that all cables areremoved from the module before installing or removing it from the NetVanta chassis.• Always remove power from the unit prior to removing or installing a module.• Improper installation may result in damage to the modules.Instructions for Installing the DIMsStep Action1 Remove power from the unit.2 If the NIM is already in the NetVanta chassis, remove all cables, release the pins at both edges of the NIMfront panel and slide the module out of the chassis.3 Carefully align the P1 connector on the NIM with the J1 connector on the DIM. Using only fingertippressure so that neither circuit board bends or flexes, ensure that the connectors are firmly seated.Secure the DIM to the NIM using the screws and standoff posts supplied. See Figure 36.4 Slide the NIM with the DIM attached into the NetVanta chassis, continuing with the normal NIM installation(refer to Instructions for Installing the NIMs below).