ADTRAN NetVanta 3200 series Hardware Installation Manual

Also see for NetVanta 3200 series: Hardware installation guide Quick reference guide Hardware installation guide Hardware installation guide Hardware installation guide

Contents

ADTRAN NetVanta 3200 series Hardware Installation Manual Manual pdf 78 page image

Unit Installation NetVanta 3200/3300/3400 Series78 Copyright © 2012 ADTRAN, Inc. 61200860L1-34ABInstalling SODIMM for Expandable MemoryThe NetVanta 3430 ships with a 144-pin, 128 MB SODIMM (P/N 1200828G1) installed. It can beupgraded to provide a maximum of 512 MB of memory using the 144-pin, 512 MB SODIMM(P/N 1200829G1).The NetVanta 3448 ships with a 200-pin, 128 MB SODIMM (P/N 1200812E1) installed. It can beupgraded to provide 256 MB of memory using the 200-pin, 256 MB SODIMM (P/N 1200813E1) or 512MB using the 200-pin, 512 MB SODIMM (P/N 1200814E1).Follow these instructions to install a SODIMM module.• SODIMMs are intended to be installed only by qualified service personnel.• There are three types of SODIMM memory modules used by ADTRAN: 200-pin DDR1,200-pin DDR2, and 144-pin DDR2. Although these modules look very similar, they arenot interchangeable. Prior to beginning the upgrade process, make sure you havepurchased the correct upgrade module for your ADTRAN product.• Before touching electronic components, make sure you are properly grounded. Bywearing a wrist strap (or using some other type of static control device), you can preventstatic electricity stored on your body or clothing from damaging your installation.Instructions for Installing SODIMMStep Action1 Remove power from the unit.2 Remove the screws holding the base unit and the cover together, and, if necessary, the two mountingbrackets.3 Using a 3/16-inch hex driver, remove the two jack screws located on either side of the DB-9 port (ifapplicable).4 Carefully lift and remove the unit’s cover to expose the circuit board.5 Remove the old SODIMM by pulling outward on the clips (shown in Figure 41 on page 79) to release themodule. Gently pull the module out of the memory slot.6 Once you have discharged your static electricity, pick up the SODIMM by its top or sides. Do not touch thegold contacts at the bottom.7 Gently insert the module into the memory slot at a slight angle (approximately 30 degrees) as shown inFigure 39 on page 79. Note that the socket and module are both keyed, which means the module can beinstalled one way only.8 To avoid damage, do not use excessive force. To seat the module into the socket, apply firm, even pressureto each end of the module (see the arrows in Figure 40 on page 79) until you feel it slip down into thesocket. If you are having problems getting the module to seat properly, try rocking the module up and downslightly, while continuing to apply pressure. When properly seated, the contact fingers on the edge of themodule will almost completely disappear inside the socket.9 With the module properly seated in the socket, rotate the module downward, as indicated in Figure 41 onpage 79. Continue pressing downward until the clips at each end of the socket lock into position. With mostsockets, you will hear a distinctive CLICK, indicating the module is correctly locked into position.10 Replace the unit cover, screws, and mounting brackets.11 Restore power to the unit.