AEG 10366MM-MN User Manual

Contents

Changing from natural gas toliquid gas1. Fully tighten the bypass screw.2. Put the knob back.Changing from liquid gas tonatural gas1. Unscrew approximately one turn thebypass screw position A.2. Put the knob for the hob back.3. Connect the appliance to theelectricity.WARNING!Put the mains plug intothe mains socket only ifall parts are back intotheir initial position.There is a risk of injury.4. Light the burner.Refer to "Hob - Daily use" chapter.5. Turn the knob for the hob to theminimum position.6. Remove the knob for the hob again.7. Screw on slowly the bypass screw tillthe flame becomes minimum andstable.8. Put the knob for the hob back on.14.12 LevellingCAUTION!Remove all the accessoriesfrom the oven.1. Disassemble the pan supports and allthe burner assemblies.2. Put the appliance on the sidewall ona clean and smooth surface. Placeeach foot into a separate hole, in theplinth, and rotate it clockwise.B3. If the floor is not equally flat, use theadjustable feet on the bottom of theappliance to set a stable position forthe appliance.ENGLISH 27