13Mounting the cooker hood - Fig. 8 Position the template (1) on the wall and mark the position, and drill theholes (2 x Ø 8 mm).Mount the two rawl plugs with the hooks (3) Hang the hood on the hooks and level it with the adjustment screws (4) Remove the grease filters (5) and mark for the two screws (6). Removethe hood and drill the holes (2 x Ø 8 mm). Insert the rawl plugs (7) and hang the hood on the wall again. Adjust ithorizontally with the screws (8) and secure it with the screws (9) Mount the chimney holder (10) with the rawl plugs (9a) and the screws(11).Be careful that it is centered over the hood and horizontally aligned.Fitting for ducting (S)Connect a tube between the hood air outlet and the wall or roof exhaustchannel. Fix it with the tube clamps supplied.Fitting for recirculationMount the recirculation spigot (12) with the two screws (13) supplied.Mounting the chimney Place the chimney and fix it to the top chimney holder with the twoscrews (16) supplied. Lower the bottom part of the chimney and fasten it to the top of thehood with two screws (17), supplied.Note that the top part of the chimney can be mounted with the side grids upor down. For use as a recirculation hood it must be mounted with the gridsupwards. (Fig. 7).Fig. 7

Description of the cooker hood

Using the cooker hood

led indicator lights for verifying the saturation of filters

Maintenance and cleaning

remove the upper glass panel

Service and Spare Parts

Guarantee Conditions

Technical data

Installation

mounting the chimney

AEG 2600D Operating And Installation Manual

2600 D

Safety warnings

Description of the Appliance

Control Panel

LED Indicator lights for verifying the saturation of filters

Maintenance and care

Charcoal filter

Remove the upper glass panel

Cleaning

Technical Specifications

Electrical connection

Mounting

TSCH