6. CLOCK FUNCTIONS6.1 Clock functions tableClock function ApplicationTime of day To set, change or check the time of day.Minute Minder To set countdown time. This function has no effect on the op-eration of the appliance.Duration To set the cooking time of the oven.End To set the time of day when the oven should deactivate.You can use the functionsDuration and End atthe same time to set thetime for how long theappliance should operateand when the applianceshould deactivate. This letsyou activate the appliancewith a delay in time. First setthe Duration and thenthe End .6.2 Setting the clock functionsFor Duration and End , set anoven function and temperature ofcooking. This is not necessary for theMinute Minder .1. Press again and again until theindicator for the necessary clockfunction starts to flash.2. Press or to set the time for thenecessary clock function.The clock function operates. The displayshows the indicator for the clock functionyou set.For the Minute Minderfunction the display showsthe time left.3. When the time ends the indicator ofthe clock function flashes and anacoustic signal sounds. Press abutton to stop the signal.4. Turn the knob for the oven functionsand the knob for the temperature tothe off position.With the Duration andEnd functions, theappliance deactivatesautomatically.6.3 Cancelling the clockfunctions1. Press the again and again untilthe necessary function indicatorflashes.2. Press and hold .The clock function goes out after someseconds.7. USING THE ACCESSORIESWARNING!Refer to Safety chapters.7.1 Inserting the accessoriesWire shelf:Push the shelf between the guide bars ofthe shelf support and make sure that thefeet point down.www.aeg.com10