AEG S53400CSS0 User Manual

InstallationFor electrical connection carefully follow the instructions given in specific paragraphs.• Unpack the appliance and check if there are damages on it. Do not connect the appli-ance if it is damaged. Report possible damages immediately to the place you bought it.In that case retain packing.• It is advisable to wait at least four hours before connecting the appliance to allow the oilto flow back in the compressor.• Adequate air circulation should be around the appliance, lacking this leads to overheat-ing. To achieve sufficient ventilation follow the instructions relevant to installation.• Wherever possible the back of the product should be against a wall to avoid touching orcatching warm parts (compressor, condenser) to prevent possible burn.• The appliance must not be located close to radiators or cookers.• Make sure that the mains plug is accessible after the installation of the appliance.• Connect to potable water supply only. 4)Service• Any electrical work required to do the servicing of the appliance should be carried out bya qualified electrician or competent person.• This product must be serviced by an authorized Service Centre, and only genuine spareparts must be used.Environment ProtectionThis appliance does not contain gasses which could damage the ozone layer, in either itsrefrigerant circuit or insulation materials. The appliance shall not be discarded togetherwith the urban refuse and rubbish. The insulation foam contains flammable gases: the ap-pliance shall be disposed according to the applicable regulations to obtain from your localauthorities. Avoid damaging the cooling unit, especially at the rear near the heat exchang-er. The materials used on this appliance marked by the symbol are recyclable.OPERATIONSwitching onInsert the plug into the wall socket.Turn the Temperature regulator clockwise to a medium setting.Switching offTo turn off the appliance, turn the Temperature regulator to the "O" position.Temperature regulationThe temperature is automatically regulated.To operate the appliance, proceed as follows:• turn the Temperature regulator toward lower settings to obtain the minimum coldness.4) If a water connection is foreseen.6 Operation