Clamp-on Ground Resistance Tester Model 6417 336.2.1 Making a Measurement■ Turn the rotary switch to the A position, and wait several seconds whilethe instrument performs internal calibration.■ Clamp around the conductor to be measured. If the clamp is incorrectlyclosed, the icon is displayed.■ If necessary, use the HOLD button to freeze the measurement.■ If necessary, use the MEM button to store the measurement.Once the measurement has stabilized, the display will indicate the value of thecurrent flowing in the conductor.NOTE: If the preset alarm threshold isexceeded, the threshold set value and thevalue of the current measured blink.Figure 6-106.3 Rotary Position - (MR)The MR position (Memory Recall) is used to display measurements previouslystored when the MEM button was pressed.6.3.1 Displaying Stored Measurements■ Set the function switch to the MR position.■ The type of data that is displayed is dependent on whether Standard orAdvanced mode was selected during SET-UP (see § 4.4, menu #9).6.3.1.1 Data Displayed in Standard ModeThe last measurement is displayed. The MRsymbol and the sequence number of therecord being recalled are also displayed.Figure 6-11 illustrates an impedance plus acurrent measurement (Ω+A setting).Figure 6-11www. GlobalTestSupply .comFind Quality Products Online at: sales@GlobalTestSupply.com