Aaeon ECM-5716 Series User Manual

Contents

Aaeon ECM-5716 Series User Manual Manual pdf 106 page image

ECM-5716 SeriesECM-5716 Series User’s Manual 935. To complete the driver installation and start the driver services, please reboot thecomputer.6. POST MessagesDuring the Power On Self-Test (POST), if the BIOS detects an error requiring you to dosomething to fix, it will either sound a beep code or display a message.If a message is displayed, it will be accompanied by:PRESS F1 TO CONTINUE, CTRL-ALT-ESC OR DEL TO ENTER SETUP6.1 POST BeepCurrently there are two kinds of beep codes in BIOS. This code indicates that a videoerror has occurred and the BIOS cannot initialize the video screen to display anyadditional information. This beep code consists of a single long beep followed by twoshort beeps. The other code indicates that your DRAM error has occurred. This beepcode consists of a single long beep repeatedly.6.2 Error MessagesOne or more of the following messages may be displayed if the BIOS detects an errorduring the POST. This list includes messages for both the ISA and the EISA BIOS.6.2.1 CMOS BATTERY HAS FAILEDCMOS battery is no longer functional. It should be replaced.6.2.2 CMOS CHECKSUM ERRORChecksum of CMOS is incorrect. This can indicate that CMOS has become corrupt. Thiserror may have been caused by a weak battery. Check the battery and replace ifnecessary.6.2.3 DISK BOOT FAILURE, INSERT SYSTEM DISK AND PRESS ENTERNo boot device was found. This could mean that either a boot drive was not detected orthe drive does not contain proper system boot files. Insert a system disk into Drive A: andpress . If you assumed the system would boot from the hard drive, make sure thecontroller is inserted correctly and all cables are properly attached. Also be sure the diskis formatted as a boot device. Then reboot the system.6.2.4 DISKETTE DRIVES OR TYPES MISMATCH ERROR - RUN SETUPType of diskette drive installed in the system is different from the CMOS definition. RunSetup to reconfigure the drive type correctly.