Securityeud-0840/2.1 — I7.7 — 10.20086■ User informationYour terminal has been supplied with a Quick User’s Guide, safety information and, where appli-cable, with other terminal-specific information. You will find this and other documents for yourdevice athttp://www.aastra.com/docfinder.More information on your terminal can be found in the documentation or your dealer’shomepage. It is your responsibility to inform yourself about the scope of functions, operationand proper use of your equipment.• Check whether you have all the user information available on your terminal, whether it con-forms to your terminal’s version and whether it is up to date.• Read through the user information carefully before putting your terminal into operation.• Store the user information within easy reach and refer to it whenever uncertainties arise inconnection with the use of the terminal.• When handing over your terminal to others, make sure you enclose the relevant user infor-mation.■ New• Changing Terminal Names Please note that with implementing the I7.7 system, theOffice 60IP / Office 60IP is renamed in Aastra 5360ip / Aastra 5360ip.• Your system administrator can set up several terminals for you that hold all the same phonenumber. If you are busy on one of these terminals, you are busy for all further incoming calls.But you are able to make further outgoing calls on the other terminals.■ Intended PurposeThis phone is part of the Ascotel® IntelliGate® communication system and is intended to beoperated on that system.Ascotel® IntelliGate® is an open, modular and comprehensive communication system that com-prises the IP-PBX (referred to in the end-user information as “the system”), a vast number ofexpansion cards and modules, and a complete series of system terminals including IP systemterminals. The system and all its component parts were designed to cover in full all the telecom-munication requirements of companies and organisations with a single user-friendly solution.The individual components of the overall system are fully compatible and must not be used forother purposes or replaced by third-party components (except when connecting other author-ized networks, applications and terminals to the interfaces provided specifically for that pur-pose).