AbleNet SuperTalker Quick Start Manual

AbleNet SuperTalker Quick Start Manual Manual pdf 1 page image

Record Messages4Overlays and ideas at www.ablenetinc.comEnter Record Mode3Powering SuperTalker1Quickstart Guide:SuperTalker™ progressive communicatorInsert four AA batteries into the device as shown. PowerOn/Off is located on the spine of the device.Select Level and Grid2With the desired Overlay and Keyguard in place:Select a LEVEL (1-8) and Grid (1, 2, 4, 8) using thecontrols on the spine of the device.NOTE: Be sure to match the Grid number to the Keyguardand Overlay currently installed on the device.For information on Overlays, Keyguards and Helpful Tips, seereverse.Press and Hold the RECORD button until the RECORDLight activates, then Release.Press and Hold the desired Message location, beginspeaking when you hear a beep. Release when finished.Repeat for additional messages.RECORD Light will flash while recording.NOTE: Speak close to the microphone for loud, clear sound.Exit Record Mode5Press and Release the RECORD button to exit RecordMode.NOTE: This device has 16 minutes of total recording time.The RECORD Light will turn yellow when only two minutesremain.Adjust as-neededPowerPress and Hold,then ReleasePress and Holdwhile speakingPress andRelease