AbleNet iTalk2 Quick Start Manual

Also see for iTalk2: Quick start guide Manual Quick start guide Quick start guide Quick start guide

AbleNet iTalk2 Quick Start Manual Manual pdf 1 page image

Enter Record Mode2Press and Hold,then ReleasePlay Messages5Record Messages3 Exit Record Mode4Insert Battery and Turn On1Quickstart Guide:iTalk2™ & iTalk2™ with Levels communicatorsConnect one 9-volt battery at the bottom of the device.Rotate the Volume ON/OFF knob to turn the device on.Press and Hold the RECORD button until the RECORDLight activates, then Release.Press and Release the RECORD button to exit RecordMode.NOTE: iTalk2 has 2 minutes of total recording time andiTalk2 with Levels has 4 minutes. The light will turn yellowand flash when only ten seconds of time remain.iTalk2 is now programmed and ready for use.a. Press and Hold a switch top, begin speaking whenyou hear a beep. Release when finished.b. Repeat for second location.RECORD Light will flash while recording.OnPress and Releaseab

/ 2

Related manuals for AbleNet iTalk2