9EnglishC Center the magnet on the sensor (seemarking strip).When the sensor is opened or closed, thestatus LED lights up once.4.3. Exclusion / Remove DeviceAClick the - (Remove) button in your Z-WaveApp and follow the further instructionsBPress the Tamper-button 3 times within 1.5seconds and the Status-LED on the base unitfront will flash 3 timesThe App will show if the Remove deviceprocess was successful and the Status-LEDon device will flash 6 timesRepeat the exclusion process from step A if itwas not successful.

Introduction

Important Safety Informations

Important information on battery disposal

Product introduction

Performance features

Mounting & Installation

Exclusion / Remove Device

Reset (Factory-Reset)

Technical Specifications

Abus SHMK10000 Manual

SHMK10000