Accent TM Hardware Manual Accent TM 1200-10 Hardware Manual 26IR SetupInfrared (IR) capability is automatically enabled with the Accent 1200.Infrared signals can be learned for almost any appliance that has a remote control. The IR area forthe device is located in the dip on the top of the case below the handle.IMPORTANT: When facing the front of the device, the IR Learning Receiver is on the left side ofthe dip and the IR Transmitter is on the right side of the dip.The following IR functions can be performed in NuVoice by using the IR SETUP Menu in theToolbox:• Add, modify, delete or rename a device/appliance• Add, change, delete and test IR functionsAdd, Modify, Delete or Rename a Device/ApplianceAdd a New DeviceSeveral devices are already setup in the Accent.To add additional devices, select Add a Device and follow the instructions on the display.Modify, Rename or Delete a DeviceUse the Up/down arrows to select the device you want to change.When the appropriate device is found, tap the button for the desired function and follow theinstructions on the display screen.Add, Rename, Delete, Re-Learn Functions• Use the Up/Down arrows to select the device that has the function to be changed.• Select Modify Selected Device• Select the function and follow the instructions on the display screen• When instructed, point the appliance’s remote control at the top of the Accent and press theappropriate function button on the remote (e.g., POWER).IMPORTANT: When teaching the device a new signal or to relearn a signal, make sure the remoteis pointed directly at the IR Learning Receiver on the left side of the headphone jack.• The Accent will beep when it receives the signal.• Select the Test Signal option to confirm that the signal functions properly.The Re-Learn All Signals option allows each signal for an appliance to be relearned without re-entering the menu each time.Sending IR Signals to an Appliance