166Appendix: XL Series Meters Factory Default SettingsXL15, 20, 25, 30, 40, 50 and 60 metersScreen Default Setting XL15 XL20 XL25 XL30 XL40 XL50 XL60Display Configuration All parameters ON ● ● ● ●Print Configuration All parameters ON ● ● ● ●Data Configuration All parameters ON ● ● ● ●Sample ID MANUAL ● ● ● ●Calibration Points Single Point ● ● ● ●Print Interval LOG DATA ● ● ● ●Stable Indicator ON ● ● ● ●Cell Constant 1.000/cm ● ● ● ●Temperature Units C (Celsius) ● ● ● ●Default Temperature 25 degree Celsius ● ● ● ●Reference Temperature 25 degree Celsius ● ● ● ●Temperature Coefficient 2.100% per degree ● ● ● ●COND / RES / TDS / SAL Setup ModesAlarm Limits OFF ● ● ● ●Conductivity Standards 84 uS, 1.413 mS, 12.88 ● ● ● ●Standard Recognition AUTO ● ● ● ●Alarm Limit Low 0uS ● ● ● ●CONDAlarm Limit High 500000uS ● ● ● ●Alarm Limit Low 3.000 Ohm ● ● ● ●RESAlarm Limit High 100.000 MOhm ● ● ● ●TDS Factor 0.60 ● ● ● ●Alarm Limit Low 0 ppm ● ● ● ●TDSAlarm Limit High 300000 ppm ● ● ● ●Alarm Limit Low 0.000 ppt ● ● ● ●SALAlarm Limit High 90.000 ppt ● ● ● ●
