Appendix C ARMC/2 Remote RecoveryApplication (RRA)ARMC/2 Card Remote Recovery Application (RRA)The Remote Recovery Application (RRA) is a recovery tool that can be executed from aremote client system located on the same network as the ARMC/2 card. You can use it torecover a failed flash attempt.To run the ARMC/2 Remote Recovery Application (RRA), double left click on theRRA.exe icon.Note: You must physically set the ARMC/2 card you want to recover into Recovery Mode. Todo this, simply short pins two and three on jumper JP12 on your ARMC/2 card.Note: Your ARMC/2 card must be write enabled before you can flash an image to it. Confirmthat pins one and two on jumper JP11 are shorted on your ARMC/2 card.Note: The firmware upgrade process is a crucial operation. Make sure that the chances of apower or connectivity loss are minimal when performing this operation.Note: You must configure the card parameters before you can start flashing your ARMC/2card’s firmware.Cont’dAppendix D : Troubleshooting 125
