Chapter 7 General Front Panel Operation 107Setting the Transfer WidthThe controller supports 8-bit SCSI and 16-bit SCSI. Enable “WideTransfer” to use the 16-bit SCSI function. Disabling “Wide Transfer”will limit the controller to 8-bit SCSI.Press ENT for two seconds to enter theMain Menu. Press t or s to select "Viewand Edit SCSI Channels", then pressENT.SCSI channel information will bedisplayed on the LCD. Press t or s tobrowse through the information of everySCSI channel. Press ENT on the channelyou wish the transfer width changed.Press t or s to select “Set TransferWidth”, then press ENT.The current mode will be displayed onthe LCD. Press ENT to continue.Press ENT again for two seconds.Every time you change the SCSI Transfer Width, youmust reset the controller for the changes to takeeffect.View and EditSCSI Channels ◊CH0=Host PID=0SID=NA SXF=20.0MSet TransferWidth ..Wide TransferEnabled ..DisableWide Transfer ?