Altos G330 Installation Configuration Guide 32Software RequiredThe management utility of onboard SATA RAID can be found in the G330Resource CD build 100 (or later).Software Version Directory on Resource CDOnboard SATARAID MonitorUtility1.11.0 \APP\G330\SATARAID\Monitor\linux\Configuring Onboard LSI SATA RAIDPlease refer to the Appendix B. for the onboard LSI SATA RAID configuration.Installation Tips1. Since Red Hat Enterprise Linux 4.0 Update 3 cannot recognize theonboard LSI SATA RAID, you need to make a driver diskette from theResource CD first before the installation.2. Type linux dd when the prompt boot: appears at the start.3. Follow the instruction to load onboard LSI SATA RAID driver from thedriver diskette from floppy (fd0).4. At Package Defaults page, select Customize the set of packages to beinstalled. And select Development Tools under Development in thePackage Group Selection.5. Follow the normal procedure to finish the installation.Gigabit Ethernet Driver InstallationThe Red Hat Enterprise Linux 4.0 Update 3 can detect the onboard Intel 82573E.But we recommend replacing the driver with the one in G330 Resource CD.1. Stop the network interface# service network stop2. Remove the module e1000# rmmod e10003. Make the driver diskette for G330 Resource CD.4. Copy driver from floppy to hard disk# mount /media/floppy# cp –R /media/floppy/. /tmp/5. Change the directory to the driver source and install the driver# cd /tmp/src/# make install# insmod e1000.ko
