Chapter 2: Using the Command Line Utility ● 15LogicalDrive|JBOD ALL deletes all logical drives or JBODs.Noprompt is an optional parameter that suppresses alert messages.ExamplesARCCONF DELETE 1 LOGICALDRIVE 1 2 3ARCCONF DELETE 1 JBOD ALLarcconf driverupdateUpdates Windows device drivers. When given a directory name, it will attempt to update adriver to the version found in the given directory.Note: This command is available only on Windows systems.SyntaxARCCONF DRIVERUPDATE ParametersDriverupdate is the directory path containing the driver that you want to update.ExampleARCCONF DRIVERUPDATE C:\WINDOWSALLarcconf failoverTurns automatic failover on and off.SyntaxARCCONF FAILOVER ParametersController# is the controller number.On turns the controller failover mode on.Off turns the controller failover mode off.ExampleARCCONF FAILOVER 1 ONarcconf getconfigLists information about the controllers, logical drives, and physical devices. This informationcan include (but is not limited to) the following items:● Controller type● BIOS, boot block, device driver, and firmware versions● Logical drive status, RAID level and size,● MaxIQ cache status (enabled/disabled), cache policy (low, medium, high), and read/writebalance● Device type, device ID, presence of PFA, SSD status (SSD or not, part of MaxIQ pool,MaxIQ pool compatibility)