Adaptec ARO-1130CA Installation And Hardware Manual

Contents

Adaptec ARO-1130CA Installation And Hardware Manual Manual pdf 41 page image

4-3Installing Software on a Windows NT System3 Press S to skip autodetection of your SCSI host adapter.4 Press S again to specify an additional device.5 Press Enter to select Others; insert the Adaptec Array100Family Manager Set drivers diskette in your floppy disk drive.6 The screen displays the adapter drivers supported on thediskette. Select the Adaptec Array1000CA Family Adapter andpress Enter.7 If you want to add drivers for other host adapters (other thanthe ARO-1130CA), do so at this time by pressing S and repeat-ing Step 5 for each additional adapter and inserting the appro-priate disk provided by the hardware manufacturer.8 Press Enter to continue with the Windows NT operatingsystem setup. Follow the onscreen instructions in the WindowsNT documentation to complete the installation.Installing the Driver When Windows NT is Already InstalledTo update or install thecda1000.sys driver if Windows NT isalready installed, follow the instructions below.Updating Windows NT 4.0To install thecda1000.sys driver when Windows NT 4.0 is alreadyinstalled, follow these steps:1 Start Windows NT.2 Click the Start button on the Windows NT task bar, and thenpoint to Settings.3 Click the Control Panel.4 Double-click the SCSI Adapters icon.5 Click the Drivers tab, and then click the Add button.6 In the Install Driver window, click the Have Disk button.7 Insert the Adaptec Array1000CA Family Manager Set driversdiskette into drive A; enter the following path to the installa-tion files and then click OK.a:\winntThe Adaptec Array1000CA Family Adapter is highlighted bydefault.