Adaptec ARO-1130CA Installation And Hardware Manual

Contents

Adaptec ARO-1130CA Installation And Hardware Manual Manual pdf 46 page image

5-2ARO-1130CA Installation and Hardware GuideDefault SCSISelect SettingsThe default SCSISelect settings, shown in the table below, are appro-priate for most systems. For situations where you might want orneed to change the settings, see the descriptions of each settingbeginning on page 5-5. To change any setting, or if you would like torun the SCSISelect utilities, see Starting the SCSISelect Utility onpage 5-3.1 If Wide SCSI is not supported on the motherboard, the default setting is 20.0 MBytes/sec.2 This option is available only if Wide SCSI is supported on the motherboard.SCSI Bus Interface Definitions DefaultHost Adapter SCSI ID 7SCSI Parity Checking EnabledHost Adapter SCSI Termination EnabledHost Adapter UltraSCSI DisabledSCSI Device Configuration DefaultInitiate Sync Negotiation Yes (Enabled)Maximum Transfer Rate 40.0 MBytes/sec. 1Enable Disconnection Yes (Enabled)Initiate Wide Negotiation 2 Yes (Enabled)Send Start Unit Command No (Disabled)Include In BIOS Scan Yes (Enabled)Additional Options DefaultArray 1000 BIOS EnabledBIOS Support for Bootable CD-ROM Disabled