Appendix E: Using the Adaptec Flash Utility ● 110Updating the Flash Using the AFU Command Line1 Create the firmware floppy disks (see page 106).2 Power off your computer, insert the first AFU floppy disk, then power on your computer.If your computer isn’t set up to boot from the bootable floppy disk, enter the system setuputility to change the setting.3 At the DOS command, if you have multiple controllers and you don’t know the number ofthe controller you want to update, type AFU LIST, then press Enter. Otherwise, skip to thenext step.4 At the DOS command, type AFU followed by a command (see page 107) and any switchesyou want.5 Update the flash using the instructions suitable for your requirements:● To update a single RAID controller:AFU UPDATE /C <cont_number>Where <cont_number> is the number of the RAID controller whose firmware youare updating. For example, to upgrade Controller 0, type AFU UPDATE /C 0● To update multiple RAID controllers:AFU UPDATE /C <cont_number_a>,<cont_number_b>Where <controller_number_a> and <controller_number_b> are thenumbers of the Adaptec RAID controllers whose firmware you are updating. Forexample, to upgrade controllers 0, 2, and 3, type AFU UPDATE /C 0, 2, 3● To update all RAID controllers simultaneously:AFU UPDATE /C allNote: The UFI file identifies the RAID controllers, so you don’t have to worry aboutflashing the wrong controller.6 When prompted, insert the first firmware disk into your floppy disk drive.The AFU reads the first disk.7 When prompted, remove the first firmware disk and insert the second firmware disk intoyour floppy disk drive.8 Repeat Step 7 as required until the flash update is complete.
